Cut 1 panel for back of bag, 15" x 18"
Front of the bag
Press the seams toward the inside.
Topstitch each side of the middle panel. I use my Accuquilt for this flower, and I use a bonding agent called Heat-N-Bond. I cut a square of fabric for the flower and apply Heat-N-Bond to it.
I usually use a Blanket Stitch to outline the flower, but a straight stitch will also work.
The inside lining is 2 pieces cut 15" x 18". In this particular bag, I doubled the fabric because it was thin, and I wanted the bag to be a bit stronger for books.
The tabs are attached about 3" from the bottom of the bag. As you can see, they are attached to the outer pieces. I would suggest doubling the tabs to make them sturdy. Just use your own judgment about the size...probably 6" wide, then folded in half, and then inserted into the side seams. You don't want the opening too large...just enough to feed the cord through and tie a knot at the bottom.
The lining is inserted into the outer bag with right sides together. The gusset is pinned in between the lining and the outer bag (3 pins above are holding gusset in place). Stitch all the way around, but leaving an opening to turn (about the size of your hand). The gusset is 6" x 10". I fold the fabric in half and sew the ends...3" x 10", and then fold in half again. You MUST do this so the cord can be fed through the top of the bag.
No comments:
Post a Comment